Door Lock Replacement Costs & DIY Tips
Most door lock units for your front door last between five and seven years, though this can vary depending on whether the environment is dry or if it gets direct sun exposure. In this post, we're covering practical, real-world info on everything from replacement costs to DIY installation tips.
When we're out on a job, the most common reasons a lock stops working are dead batteries or water damage to the mainboard. If the keypad won't light up at all, try replacing all four batteries with brand-new alkaline ones first. If there's still no response, then you can assume the unit is broken. For major brands like Samsung or Gateman, you can temporarily open it by placing a 9V square battery on the emergency power terminal.
When you're replacing an old lock with a new model, you absolutely must check the size of the drilling holes. If you're switching from an old lever-style auxiliary lock to a push-pull model, you might need to drill extra holes, so it's safest to measure the specs beforehand. If you're doing it yourself, be careful—if the strike plate location on the door frame is off, the locking pin might get stuck, preventing the door from closing properly.
| Task | Hiring a Technician | DIY Installation |
|---|---|---|
| Time Required | Around 30 minutes | Around 1 hour |
| Average Cost | 30,000 KRW ~ 60,000 KRW | Only part cost |
| Risk of Failure | None | Potential for drilling errors or incorrect wiring |
There are clear differences in security performance and price depending on the product type. Basic models that only support numbers and card keys start in the low 100,000 KRW range, but high-end models with fingerprint recognition or double security features can easily go over 300,000 KRW. You must use alkaline batteries; using manganese batteries can cause leaks that corrode the circuit board.
If your door won't close completely or won't lock automatically, the problem is likely with the magnetic sensor. If the gap between the door frame and the lock body is more than 5mm, the sensor won't detect that the door is closed, so the auto-lock won't engage. Also, be careful not to force the door open or shut when it's locked in manual mode, as this can wear down the mortise gear.
Frequently Asked Questions About Door Locks
What should I do if my keypad suddenly stops working?
If you enter the wrong code more than five times, the security system will lock the keypad for one minute. In this situation, just wait a moment, then try entering the correct code, or use your registered key card or fingerprint to unlock it immediately.
What if I drill the wrong hole while installing it myself?
If your drilling location is off, you'll need to cover the hole with a steel reinforcement plate and then drill a new hole. You can easily find these reinforcement plates online or at a hardware store, and they help you finish the look neatly.
My batteries drain too quickly even though I change them often?
The cause could be moisture getting into the circuit board or excessive current drain from friction on the mortise lock bolt. Mixing lithium batteries with standard manganese batteries will drastically reduce their lifespan, so you must replace them all with alkaline batteries from the same manufacturer.
After finishing the installation, make sure to test it while leaving the door unlocked to prevent yourself from getting locked out later.
